Northeastern Exhaust | Direct Fit Stainless Steel Exhaust System Kit Compatible for Toyota 1997-2001 Camry 2002-2003 Solara 2.2L 2.4L - Include Gaskets and Clamp

fit like it should, good puality!!

So the install was surprisingly easy. If it wasn't for few rusty bolts that broke off, I would be done in 3-4 hours. Few things to keep in mind though. This system replaced my 3 years old completely rusted out setup by Walker.1. The muffler is larger than my old one although sims like it filled the space pretty well.2. The gasket that came with the resonator pipe was thinner than one from Walker and it had a small leak when tight it by hand. I had to use a power tools to had it tighter to stop the leak. So far so good or at least can't feel any air coming out from around the connections.3. The two piece resonator pipe has to be connected with a U-Bolt clamp that was included. I myself on the other hand ordered another U-Bolt from Amazon that was Stainless Steel since the included one wasn't stainless steel. I'm not sure why either the u-bolt or the stud nuts and washers connecting muffler to the resonator pipe that came with the full SS system were not stainless steel? U-Bolt Clamp size is 2 inches. The back pipe is smaller diameter than the resonator pipe. The way you had to connect them together was to slide the resonator pipe into the smaller back piece. The back pipe's end was expended to larger size and it had few notches in it so I wasn't really sure where to place the clamp but I decided to put it in the middle of the connection right before the nutches. So far no leak. Overall, nice looking pipes and the SS may give me few extra years of rust free driving in Chicago.

Two different size gaskets large for front small for rear, bought a stainless steel stepped exhaust clamp to replace heavy duty steel clamp they sent, other than that it's a great exhaust system.

Cant beat the price. It fits ok but hangs lower than the original. Not a problem though. Only complaint was the bolts they supply were too large to fit through the holes to connect it to the front half of the exhaust.

didnt fit the car

easy installation and fit

Awesome

It's delivered 5-13 days earlier ! It's good quality except the clamp is not stainless steel.It works for my 2001 Camry 4 Cylinder Model, but the resonator pipe or the back piece is 1-2 inch short.To make two pipes overlapped 1 inch, the pipes will pull Muffler 1 inch towards front of car.The current pipes' length is perfect for the one without notches design. The notches make the pipe length at least 1 inch unusable. For the current thickness of the pipe, without notches, the clamp still can seal the pipes' overlap section perfectly. The notches should be removed for next generation of this product.Edited on 4-12-2021: I can see the rusty after this winter.