AmazichaChrome Mid Frame Air Deflector Compatible for Harley Davidson Touring Electra Glide/Street Glide/Road Glide/Tri Glide/Road King 2009-2016 Models Without Cool Flow Fan

They work great keep the heat off your legs and look great on the bike cheaper than Harley brand and easy to install. Time will tell if the hold up in the long run had on for a few months now

Let me start by saying these are hands down a great product for a fraction of the cost of the HD version and they come gloss black already. Paint finish is perfect and the fit is perfect. Now for the installation with this you need to be a little handy and patient and be advised you will need 3 nuts as they don’t come with the package and you’ll need 3 additional flat fender washers that also don’t with the package. The left side deflector you use the existing threaded hole in the frame for the top hole and you’ll nut and bolt the lower hole using a total of 2 bolts supplied in the package along with 3 washers and 1 nut on this side. You’ll need to remove the Seat and the side cover and loosen the plastic housing holding the ecm and push it aside to get your fingers in to instal the nut on the back side. For the right side you’ll need 2 bolts supplied in the package along with 2 additional washers supplied by you and 2 nuts supplied by you. This side you cannot use the existing threaded hole in the frame unless you drill another hole in the deflector which would be very hard to measure accurately so the easiest way is the nut and bolt the top and bottom. Remove the side cover and you’ll be able to access the back side of the frame to instal the nuts. It’s a tight fit but with someone holding a flash light and a retractable magnet it’s doable. Great product just be patient you’ll be happy when it’s all done and the money you saved.

I got these out of the package and was immediately impressed with the quality of the finish and how well it matched the vivid black on my bike. However, it didnt come with the nutsert needed for the upper right side, so I had to make a trip to the dealer parts counter to get it. Difficulty of installation is not due to the product but clearance issues on the bike that makes it hard to get the hardware in place

Did not fit but was my fault for not reading the whole description and what would fitReturn was done easy transaction

No mounting hardware. Can't use them. Waste of money.

These heat deflectors are hard to install regardless of which ones you buy because the rear head is so close to the frame. But once you figure it out, they look great and deflect the heat.

Fits and works. Word of advice , buy good hardware for the install. The included hardware is as cheap as it comes.

I was a bit skeptical at first, but for $20 figured what the hell. Now I am super impressed with these. They look amazing! When Harley only offers a matt black set, I knew I needed chrome. These came with almost everything needed to install. The only additional hardware I needed were the U nuts for the top mounting hole on the bike. I purchased them from my Harley dealer, although they can probably be found at any hardware store too. Surprisingly the driver side was much easier to install than the passnger side, even though the bike leans left while parked, there is much more room to work with big hands or fingers than there is on the passenger side. Make sure you have a 10mm wrench to tighten the bolts as even my smallest ratchet didn't fit where I needed it. I still haven't ridden so I can't speak on how well they deflect the heat, but the price is worth it evem for the look. Beautiful chrome finish, and I didn't experiemce any scratches. Total install took 30-45 minutes.