Pipefitter Square Holder & Combo Level V2 (Silver)

• Pipefitter & Fabricator Square Holder & Combo Level tool (only metallic silver available now), with a strong magnet to secure down the squares on pipe allowing the fitter/fabricator to hand free use the tape measure to pull measurements or eyeball the squareness + level of his pipe for a good fit. With this tool the fabricator/fitter can make a perfect fit without depending on extra people to hold the squares for him. Good tool to keep social distancing while making a fit due to COVID-19..
• To insert the square loose the thumbscrews locate in the back of tool, insert the square through the holder's legs gap, then tight the thumbscrews to secure the square between the square holder's legs..
• The thumbscrews can also be used to tie the tool tethers when working on elevated areas to avoid dropping objects..
• With this square holder tool, the fabricator/fitter can safely make a perfect fit without depending on extra people to hold the squares for him. It is easy to use and secure. Very handy when working on tight areas, unstable scaffolds decks or jack stands given that this tool will securely hold down the square to the pipe and will not move or fall even if the scaffold or the jack stand is shaking..
• To Calibrate the levels, slightly loose the 2 levels screws and slowly move the levels as needed to set it level then slowly snug tight the screws..

Pipefitter & Fabricator Square Holder & Combo Level tool, with a very strong magnet to securely hold down the squares on the pipe allowing the fitter/fabricator to hand free use the tape measure to pull measurements and square + level the pipe making a good fit. With this tool the fabricator/fitter can make a perfect fit without depending on extra people to hold the squares for him (REMEMBER SOCIAL DISTANCING). It is safe and easy to use. Very handy when working on tight areas, unstable scaffolds decks or jack stands given that this tool will securely hold down the square to the pipe and will not move or fall even if the scaffold or jack stand is shaking or moving. - To insert the square loose the two thumbscrews from the backside, insert the square through the holder's legs gap, then tight the thumbscrews to secure the square between the holder's legs. - Use the thumbscrews to tie the tool tether to the square holder when working on elevated areas to avoid dropping objects. - Excellent tool for Fabricators, Pipefitters, Plumbers, Ironworkers and many other crafts that uses the framing square to align and square pipes, steel, sheet metal, walls, etc. - Made of high quality lightweight aluminum, and very strong magnets that securely hold down the Square to the working surface (pipe, steel, etc.), allowing user to hand free complete other fitting tasks. Has a combination of levels to level the working surface. - To Calibrate the combo-levels, just loose the 2 screws and slowly move the levels as needed to set it level then slowly snug tight the screws. - If working on non-magnetic materials (stainless steel, aluminum and PVC pipes, etc.) use rubber band or the tool tethers. Pass the rubber band around the pipe and securely tie the square holder to the pipe (as show in one of the products picture above), then use the tool to hold your squares as normally. - The square holder can also be used to level and square small nipples, your truck's trailer and campers too.