MR1100

OK so this was second attempt with a Netgear Nighthawk MiFi router. Initially I got the more advanced (and expensive) M2 version but I was unable to get that to work. So it was a toss-up get another M2, M1 or something else entirely, in the end went with the cheaper M1 version. Completely different experience to previous M2. Insert SIM, battery & charge for couple of hours. Use iPhone to connect to it's WiFi network and all was good, iPhone connected and connected onwards to internet straight away with no further intervention. It picked up the APN settings automatically something the M2 failed to do. I was going to deducted a star because I was unable to get the Netgear App designed to manage the device to connect to it. However this isn't essential as once set up you can log into the router through a web browser and manage it there. Just put it's IP address (192.168.1.1) into your browsers address (URL) bar and hit enter. Once into the user interface I finished the set up there. So on balance the App probably doesn't add much anyway... I actually got this for my elderly Dad who's in a care home that dosent provide residents with internet access so this device is to give him internet access on his devices principally Netflix. Pleased to report that it's doing this well and he says there's now no buffering and the picture quality is much improved over previous device. I suspect the provision of a single ethernet port on the device which I used to connect to his TV helps here. In fact the ethernet port was one of the reasons I picked the Netgear Nighthawk M1. Only been in use for a couple of hours but at this point working well, I'll edit this review if anything changes my view on this product. On balance I think the M2 version I ordered first and returned was just a bad copy, unusual but stuff happened and nothing is perfect 100% of the time.

I work in IT remotely in the Scottish Highlands with local BT broadband delivering insufficient speeds for both download and (increasingly important for zoom/teams calls) upload. Hence the need for a 4G router. This unit, in conjunction with a Poynting 4G-XPOL-A0002 directional antenna is making the most of the two bar signal from the nearest mast on the EE network. Typical download speed is 70 mbs but I’ve seen 123 recently! Upload is consistent at about 10mbs. My work colleagues in different cities/towns in the UK can’t believe it when I screenshare the results of a speedtest (and neither can I). Like some other reviewers it did seem to take a lot more fiddling (and frustration) to setup than I’d expect. It really ought to just be a case of popping in the SIM and away you go, but for some reason it wasn’t straightforward. My top tip, if you’ve just got yourself a new SIM is to put it in your phone and do the initial activation & top up there FIRST to ensure the SIM is fully working. Only once you’re 100% sure that the SIM is working should you then proceed to use that SIM in this device. It’s only a hunch but I think that may have been the cause of some of my initial setup trauma. The unit itself feels really solid & well made. Being battery powered means it will keep working for a number of hours (I think the claim is 7?) without mains power- handy if used at home with possible power cuts. The app that comes with it (or the website used for config) has all of the features you’d expect. I use the unit as effectively our full time home router and have it plugged into the mains at all times, without the battery in place. (The battery is fully charged and just left to one side in case of power cuts - pop it in and within a couple of minutes the router is back up again). Batteries are not meant to have power flowing through them constantly and some users have reported the battery getting too hot (causing the device to shut down) and even becoming misshapen/leaking under prolonged constant charging. So if you’re planning on leaving it on all the time, I’d strongly suggest leaving out the battery. It’s important to realise that the supplied USB charger does NOT provide sufficient power to charge the unit if it is also under heavy active use at the same time. This can lead to the device powering off randomly and I suspect is the cause of some of the dissatisfaction from some users. Simply purchase a decent charger (for about £15) to solve that problem. I bought a “Quick Charge 3.0, Anker 18W 3Amp USB Wall Charger (Quick Charge 2.0 Compatible) Powerport+ 1” device from Amazon. So, ensure you use a SIM that’s already setup, buy a decent charger, and don’t leave the battery in (if you’re leaving it on constantly as a home router) and my experience has been that it’s a cracking little device and worth the extra money over cheaper devices.

So, I wanted datq but needed it to be provided into a cat5 plug. Not many choices. I went with the 4G version, yep, more than enough speed for what I needed, but future proofing its usage would have been nice, but the price on a 5G, again, with the cat5 was way above what I could justify spending. So, this was almost a compromise, whilst not being so...bare that in mind. So, how does it do?the prima5use for this is to provide data out in a fairly remote location. It's also in and or around trees..... So yep, great for signal. (There is the ability to add antennas onto this unit, to help with weak signals) I did tests with my phone SIM in a couple of locations....so so results, then I tried with a different network, and yep, 4 bars signal mostly where I was going to use this. Not that it matters, but I ended up using Smarty, and now my phone is with them too. I am only mentioning this so you could choose a low cost with no contract, so if your network 8snt good with this you have an alternative to try, and can easily get out of it if things do t work out. The other network good like this is Giffgaff, so you have a couple of networks you can try out to see what works. And remember if all of them are a bit weak, you can always get better antennas that have better gain, that you can mount higher, outside, if you are inside, and generally improve things. The performance of this unit I would class as good. It has done everything I have asked if it. Yes, primary use is limited and sparadic, but when I moved I ran the house from it for a good chunk of time and yep, all was good. Again, it was handy it had cat5 as I could just plug into my switches and didn't need everything trying to use the WiFi. I didn't hook up everything, but it ran enough things to make things livable. So yeah, once you accept the price, I think you will be happy. It's Netgear, so expect Netgear quality and reliability. This doesn't use an app, almost sadly, but you hook into a web interface and can have a bit of a fiddle with some settings. There isn't so much you need to do in there really, so having an app on the phone now would seem a waste, since it was all at up, I probably haven't looked at it, unlike say the house network, where you are often poking around. If you are going to be moving this around there are some cheap cases you can get for rhese, which I would recommend getting. Do t run it in the case 4goufg, let it have good airflow, especially if planning to run long term. When I did the prolonged use of this I put it on one of those defrost plates, basically a metal plate that helps move the heat away and out of the battery. I had zero issues, but I read some people had, and it sounds like it was due to 5y3 battery becoming hot. I also ran it with the usb connected, so that too probably meant the battery did not see any or not much use, and again that would help with any heat build up. HTH.

This is one honest review from a guy who travels a lot and always ends up in the worst dead spots with work ARMY ! . I needed to put an end to no signal with any smart phone, after watching several videos online I began to notice a pattern with the devices people chose, and they all recommended The Netgear Nighthawk M1. So I went ahead and purchased one just last week. I was sceptical as I couldn’t even get 4G on my phone without going outside 20- 30 meters or so , and then it was intermittent. So it arrived and I plugged it in and downloaded the Netgear app and followed the instructions and booooooom I got 4G in my room ! Then it sed 4G+ ? I did a quick speed test on my phone and it was far better than my broadband at home !!!!!! I know this is a bit of a read but hopefully Iv helped someone with there issues of no signal dead spot, I have taken this home and tested it against my internet provider which was around 65MBS NETGEAR - 100MBS !! I have now cancelled my broadband ! Thank you Netgear I don’t know how you don it but your devices are epic and I could talk to my family and steam movies in a dead spot for over 3 months deployment!!!!

I tried SIM cards from all 3 of the UK's main mobile operators, none worked, just got a message saying "Install or check SIM" - Gutted! UPDATE: I've now received a working unit - For an LTE Router its OK, fairly easy to setup and the WebGUI is snappy - But for the price, it's not worth it. Saying that, I'll keep it as it has 1 unique feature that makes this stand out - a built-in ethernet port, which allows me to plug it into my home network and use it as a main-router, and provides a proper backup to my main broadband, allowing me to continue to work and my wife to maintain her sanity (as the kids can play XBox) - If you don't need an ethernet port, then look elsewhere, even one of the Aircards, or even a cheap-mobile phone you can use as a hotspot. As somebody who works in Network Security, it's horrifying to see that Netgear is still not taking security seriously, selling flagship products such as this without even adding SSL to the admin interface. If anybody from Netgear reads this, For future versions, please consider the following: 1) Foremost - Add support for dual-sims.. To use this abroad, I'd have to dismantle it and replace the SIM 2) The current SIM slot feels incredibly dangerous, inserting the SIM takes some effort and feels like its scraping against sensitive circuitry or contacts. 2) Do NOT place the SIM card under the battery 3) The SD micro card slot really serves no value

I was a bit confused with researching mobile Sim routers, as I guess some purchasers are not as savvy as others. (It is a bit like shopping for water containers with a tap. There is a lot of negative feedback from those, with complaints of “ the tap is useless”which you should read: they didn’t loosen the lid to allow air in. User error, or faulty item ? But, I ‘m delighted to say, I have a 3 x improvement, both in Upload and Downloud, using the same SIM card, same static location, than I had before. And I have done about 30 tests, at different times, before and after. I bought this from Amazon direct, but from Warehouse, used like new. ( it was like new, still sealed). Although it seems a huge outlay, if it is important to you in getting connected with better results , I suggest Buy one! ( you can always return it if it doesn’t live up to your expectations! That’s Amazon, a great return policy. I will add, remember to set up your SIM card to get that communicating with the router. You will find that in the software, under Advanced Setting, Cellular. Click Add. Then you need the info of your SIM provider, APN etc it may be already on your phone if you look hard enough, and just add it to the list. Highly recommended from me! The battery lasts about 8 hours, but you can run it with the battery removed, as long as you have a 12v power supply. And I will add; I wasn’t paid to say this, and the item I paid full price for.

After a house move this device hold load of 35+ different devices (computers, phones, tablets, smart devices…). Generally planned to use as temporary/backup internet line for working from home, after house move (for no more than 2 - 3 days), but due to lockdown have to wait engineer visit for more than 1 month to get broadband installation. So use it as a primary internet line for a noticeable period of time. Do not use it as a router, only as a modem with pfSense router / Linksys Velop. Used with external antenna (Poynting 4G-XPOL-A0001 Cross Polarised 4G Omni LTE Antenna). An external antenna is more than recommended if modem stays indoor only as it increases the signal level and total speed. Speed varies during the day from 75Mbps down to 8Mbps on busy time (with external antenna) signal level 2-3 bars and around 10 - 2Mbps without - signal level 1 bar or no bars, so if your primary router support traffic management it really helps split traffic from important to less important during a busy time. The device handles around 30-60 Gb daily. Not always best speed, during the busy time we have to get an agreement which going to use the line as a primary person / who is secondary (kids almost always last) and adjust policies on the router. The device holding load 24/7 for a month for the whole household. If you do not have options, with its own limits can be used as a primary internet line. Consider checking cell map to find best or nearest cell mast. For signal level boost It may be beneficial if you get own mast for external antenna (not tested). Update: I got 2.5-meter mast for antenna and signal level and speed improved. So I got now 90 - 320Mbps with (3-4 bars Fair or Good signal levels). The web interface on modem provides numeric value/signal level, that you can use to adjust / point antenna close to cell direction. I got an omnidirectional antenna, and my cell not very close to the house and I don't get a direct view to it. With the directional antenna, you can get better results (not tested, but I believe so). Used it in daily camping outside the city. Kind of nice experience to take the internet with you. Very happy with the purchase.

I bought a D-link 4g router before this which was rubbish. It had a file-size download limit of 2GB which confused me for days, investigating all options of what caused failed downloads, until i learnt the router itself was causing it. This one has been great. The battery does not last long, but for home, mains use where fibre is not available it's great, i've had speeds of up to 70 or 80gbps using it.